HongJin-6610 two-component 10:1 silicone encapsulant

Brief introduction

model	HongJin-6610
Specification	50ml/branch
characteristic	HongJin-6610 is a two-component 10:1 silicone potting compound with high transparency, medium elasticity, good insulation performance, flex resistance, oxidation resistance, good heat dissipation, high and low temperature resistance (under -60 ℃ ~ 200 ℃) Long-term use), good performance, no whitening, long life, maintenance-free, anti-oxidation, anti-yellowing, stable chemical and physical properties, and superior UV resistance.
Applicable Products	It is widely used in potting and coating of LED lamps, electronic appliances, circuit boards and other products. Especially suitable for waterproof protection of LED strips.

Technical parameter

technical parameter		Acomponent	Bcomponent
Before curing	Exterior	light blue fluid	Platinum Fluid
	Viscosity（cps）	1000～2000	50～150
	The mixing ratioA:B（weight ratio）	10:1
	Viscosity after mixing（cps）	800～1600
	Dry time（min）	30～60
	curing time（h）	2～4Initial cure in hours, full cure in 24 hours, peak strength in 7 days
After curing	hardness（ShaoA）	10～20
	Shear strength，Mpa	≥0.5
	Tensile Strength，Mpa	≥0.8
	Dielectric strength（KV/mm）	≥13
	Dielectric constant（1.0MHz）	2.5～3.3
	Volume resistivity（Ω·cm）	≥1.0×1015

Precautions

1、The rubber compound should be sealed and stored in a cool and ventilated place below 30℃. The mixed rubber should be used up at one time to avoid waste.

2、This product is non-dangerous, but keep out of mouth and eyes.

3、Weighing: accurately weigh components A and B (A:B=10:1);

4、Stirring: After the two components are mixed, stir well, about 1-2min

5、Spray coating: The spray coating is subject to no leakage or sagging. The thickness of a coating film is generally between 0.1-0.3mm

5、Curing: keep the environment at 25±10℃, 55±20%RH.

|影院精品视频在线播放|天天干天天干天天干天天日天天操天天射|亚洲无码在线色视频婷婷|欧美一级2023|一级黄视频免费看|a级a级a级a片|免费91av在线

Products

PRODUCT CENTER

About Us

Products

Application

Follow us